Plate-belt dryer

Our ENERTROC plate-belt dryers can be used to dry different kinds of biomass, such as:

... The drying material is processed on the plate-belt through a inlet hopper.

A distribution conveyor provides the even distribution of material over the entire surface.

The plate-belt consitsts of plates made of perforated, powder coated tin or stainless steel.

By turning down the plates at the belts end, the drying material is shifted to the lower level. Thus the belts surface is used in both directions of travel, which has for the advantage that the footprint of the dryer is comparatively small. The dryer is modular designed.

Between the racks for the drive gears and guide rollers more ore less belt elements are installed. The processing of the drying air is done by an exhaust air fan. Optionally this can be equipped with variable frequency drive. A dust filter for the exhaust air or biofilter can be connected at the outlet side, if necessary.

The heating is done by low pressure hot water with 90°C via a heat exchanger coil mounted on the same baseframe with the dryer.

Our ENERTROC Plate belt dryers therefore can idially be used in connection with CHP´s.

Especially in German Biogas AD plants a bonus on the feed in tarrif for combined heat and power can be achieved by utilizing this technology.

In connection with our ENERBRIK Briquetting presses, valuable fuel briquettes can be produced.

Depending on the material analysis the briquettes can also be used as a fuel in the ENERCARB Woodgas Heat and power plants