ENERGIN® PPT Power Plants up to 25 MW
ENERGIN® PPT are power plants based on the parallel installation of 4-50 Generator Sets type ENERGIN® M12 GEN G500. Thereby a rated power of 2-25 MW is available. The use of this highly standardized Generator Sets offers many advantages over plants with less, but larger engines.
Highly flexible power supply
To adjust the power output, single engines can be stopped, while the others can run at full rating with highest efficiency.
Highest availability
The probability that one single 2 MW engine fails is 1,000,000 times higher than the possibility that four 500 kW engines have a failure at the same time.
Fast and easy installation
The GEN G500 units are fully pre-packaged. Pre-manufactured piping of radiators can be supplied with the units.
The handling can be done even by manual forklifts. Therefore the installation of multiple small engines is faster and cheaper than the installation of large single engines.
Reduced spare parts cost
The spare parts cost per produced kWh, are about 20-40 % less with ENERGIN GEN units compared to large engines of different brands.
Overhaul downtimes
The ENERGIN GEN units are easy to maintain and overhaul with limited demand for special tools. The engine downtime at a minor overhaul is only half compared to large engines.
Space demand
Compared with an installation of 2 MW engines an installation of four 500 kW units needs about 10 % more area but due to the lower height around 20 % less of space. In addition no overhead cranes are needed and no extra foundation is necessary.